Here's a picture of it just incase..
Edited by zombi69, 16 December 2005 - 12:50 PM.
0
Cell Sensor EMF Detector Question?
Started by
zombi69
, Dec 16 2005 12:49 PM
2 replies to this topic
#1
zombi69
-
- Member
-
- 102 posts
Junior Villager
- Location:Burlington, Ontario, Canada
Posted 16 December 2005 - 12:49 PM
I just picked this little unit up and have gone through the booklet but still seem to have abt of confusion in terms of using this for ghost detection. Those of you that use this unit, one question...Do you use the little probe that comes with it...or not? Actually two question really..Do you also have the detection set on high sensitivety or normal? Any help with this was be great and thx!!
Here's a picture of it just incase..
Here's a picture of it just incase..
Southern Ontario Paranormal Society (SOPS)-----------------------------------------------------------------------NOCTURNAL FREQUENCY RADIO
#2
CajunKnight
-
- New Member
-
- 2,504 posts
Village Elder
- Gender:Male
- Location:Tickfaw, Louisiana
Posted 16 December 2005 - 08:26 PM
This unit can be used with or without the probe. The sensitivity can be set to low and if little or no readings are present you can switch it to high to pick up the slightest fluctuations. Its best to use on low setting. You can practice with it in your home around electrical appliances and such so you can see what it does.
Welcome to ghostvillage, home of 24,000+ smiling faces and a few old grouches."Some things have to be believed to be seen"Ralph Hodgson
#3
lorddraven2000
-
- Member
-
- 150 posts
Villager
Posted 19 December 2005 - 03:14 PM
gree the low setting is usually the best with this unit
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users
