Free Skins
© Fisana

Jump to content


Photo

Cell Sensor EMF Detector Question?


  • Please log in to reply
2 replies to this topic

#1 zombi69

zombi69

    Junior Villager

  • Member
  • PipPip
  • 102 posts
  • Location:Burlington, Ontario, Canada

Posted 16 December 2005 - 12:49 PM

I just picked this little unit up and have gone through the booklet but still seem to have abt of confusion in terms of using this for ghost detection. Those of you that use this unit, one question...Do you use the little probe that comes with it...or not? Actually two question really..Do you also have the detection set on high sensitivety or normal? Any help with this was be great and thx!! ;)

Here's a picture of it just incase..

Posted Image

Edited by zombi69, 16 December 2005 - 12:50 PM.

Southern Ontario Paranormal Society (SOPS)-----------------------------------------------------------------------NOCTURNAL FREQUENCY RADIO

#2 CajunKnight

CajunKnight

    Village Elder

  • New Member
  • PipPipPipPipPip
  • 2,504 posts
  • Gender:Male
  • Location:Tickfaw, Louisiana

Posted 16 December 2005 - 08:26 PM

This unit can be used with or without the probe. The sensitivity can be set to low and if little or no readings are present you can switch it to high to pick up the slightest fluctuations. Its best to use on low setting. You can practice with it in your home around electrical appliances and such so you can see what it does.
Welcome to ghostvillage, home of 24,000+ smiling faces and a few old grouches."Some things have to be believed to be seen"Ralph Hodgson

#3 lorddraven2000

lorddraven2000

    Villager

  • Member
  • PipPipPip
  • 150 posts

Posted 19 December 2005 - 03:14 PM

gree the low setting is usually the best with this unit




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users